I was trying to replicate Freeipa from a Fedora 25/Freeipa 4.4.4 to NOT Fedora 25. How hard could it be to rebuild Freeipa 4.4.4 on Centos? It turns out it is fiddly to get the packages built.
The following is not for the faint of heart and leaves out a bunch of build environment stuff, so this is not a good package to learn rebuilding a package. But, the instructions should save you a ton of time.
Download Fedora 25’s Freeipa source. It should be in this directory: http://dl.fedoraproject.org/pub/fedora/linux/updates/25/SRPMS/f/
Download mod_wsgi source from Fedora 25. It should be in this directory. http://dl.fedoraproject.org/pub/fedora/linux/updates/25/SRPMS/m/
Download dinglibs source for Fedora 25. I found it here: http://rpm.pbone.net/index.php3/stat/26/dist/103/size/895373/name/ding-libs-0.6.0-29.fc25.src.rpm
Download cmocka source for Fedora 25. I found it here: https://kojipkgs.fedoraproject.org//packages/cmocka/1.1.1/0.fc25/src/cmocka-1.1.1-0.fc25.src.rpm
And so on for the following: ldns, python-astroid, pylint. I was unable to build the sssd version that ships with Fedora 25 and a couple of the Python packages. That means the freeipa.spec file gets modified with lower version requirements and the python package requirements get commented out and installed with pip.
There are also modifications to the spec files needed to be sure the packages don’t conflict with themselves.
The modifications to the spec files to accept a lower version of some of the packages are easy. The build script should complain the correct version isn’t available. Figure out what your distro packages and modify the spec file accordingly.
My recollection is the general order of build was:
- build mod-wsgi
- build dinglibs
- build cmocka
- build python-astroid
- build pylint
- build ldns
- build free-ipa
The freeipa build will probably fail a couple of times on simple dependencies in the spec file. Just keep adjusting the spec file and you’ll get built packages in a few tries.
Here is my freeipa.spec file. It is not perfect as a number of the packages built complain about conflicting with themselves. freeipa.spec
If, after you get the packages built and the install goes okay AND you are running in an SELinux environment, be sure to run audit2allow -w -a after the IPA server stack is up to check for policy denials.
Do This Too!
For some reason, the replication setup script demands testing TCP port 7389 as another way to reach the LDAP server. You need a port address translation for it.
firewall-cmd --permanent --zone=public --add-rich-rule="rule family="ipv4" \ source address="192.168.1.0/24" \ port protocol="tcp" port="7389" accept" firewall-cmd --permanent --zone=public --add-forward-port=port=7389:proto=tcp:toport=636:toaddr=192.168.1.88
That’s the firewall-cmd way to forward anything showing up on TCP 7389 from the LAN and sending it to 636. Adjust as needed. It works for me.